Ham Radio AllStar Link Full Duplex Repeater 144MHz 2m Motorola MAXTRAC

Description

This listing is for a complete repeater for the 2 meter amateur radio band. Allstar and echo link work and frequencies anywhere between 144-148MHz are valid.
You will need 12 volts and either two antennas or a duplexer to use this as a repeater.
This node utilizes the top of the line Motorola SPECTRA VHF transceiver, and the radio has been modified by me for use as a AllStar simplex node.
Please enter your programming configuration here when you are ready!
https://forms.gle/seR7AT2Kp1AnFvVm8 ( COPY AND PASTE)
For me to construct and configure it may take up to 7 business days to ship out the node. Additional delays may occur for parts ordering delays.
The frequency, AllStar Link configuration, and EchoLink configuration is included for free.
To setup,
1. Connect Raspberry pi to an ethernet internet connection
2. Power on node
3. Go to the frequency with your 2 meter mobile or portable radio, and enjoy worldwide connections. If you put a good antenna on the node at a good location, the range can exceed 10 miles, and you will make use out of a very quiet radio band.
A short instruction sheet will be included.
INCLUDES:
Tested Motorola MAXTRAC Mobile Radio for repeater radio
USB interface hand built to interface audio and signalling connections to the raspberry pi.
Raspberry pi running AllStar link, and custom configured to your CallSign configuration
(Raspberry pi case may vary, the one in the photo was what was on hand at the taking of the photos)
Motorola Power cable pigtails
Mini UHF to SO-239 so you can plug in a PL259 based antenna.
Please submit programming info shortly after you pay, so I know what to put in your radio.
Each Radio is individually tested and in spec to:
TX Power: 6 to 20 WATTS (Can likely go higher but will overheat for long winded conversation overheating)
RX Sensitivity: -122dBm Squelch
Frequency Error: <0.05KHz
w0sky981 at gmail